The LM-2 combines an air/fuel ratio meter, a full-function 32-channel
datalogger, and powerful software to deliver a complete tuning workshop for less
than the cost of one dyno day. Whether you have a piggy-back fuel controller,
race carb, aftermarket ECU, ODB-II tuning software, or a flash/chip programmer,
an LM-2 is the tool you need to dial in maximum HP. The meter’s digital signal
processing technology provides data on exactly how rich or lean an engine is
running at any load. The LM-2’s self-calibrating circuitry also compensates for
changes in temperature, altitude, and sensor condition.
- Patented “Direct Digital” Wideband Technology
- Wideband O2 Compatible with ALL fuel types
- Single or Dual Channel Version Available
- OBD-II Scan tool- read/clear DTCs and log up to 16
channels of CAN OBD-II Data
- Log directly to SD card (included)
- Playback log data on screen and/or with powerful
LogWorks software (included)
- Large high-contrast graphics LCD
- Built-in RPM converter (direct frequency or with
optional inductive clamp)
- 4 fully-differential analog inputs
- 2 configurable linear analog outputs
- Positive lock connectors for all connections
- Innovate MTS serial IN and OUT
- USB connection to your PC
|
|
The LM-2 also features two fully programmable linear analog outputs to
connect to analog gauges, dyno computers, ECUs, piggyback controllers, and other
devices with analog inputs. Analog output 1 comes setup from the factory ready
for narrowband simulation; analog output 2 is configured as 0 volt = 7.35 AFR
and 5 volts = 22.39 AFR. With the provided LM Programmer software these analog
outputs may also be configured by the user.
|
